NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

FastPath Tasks: Optional
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
F-11
Prerequisites
Prerequisites
The NonStop S-series and K-series servers should be in the following states.
NonStop S-Series Server
NonStop K-Series Server
State Notes
The default system configuration with which
the system was shipped is complete.
The initial OSM or TSM configuration is
complete.
See 3. Configure OSM or TSM
Environment on page E-36.
The system name and system number are
defined.
See 4b. Set System Name, Number, and
Time on page E-38.
The NonStop Kernel subsystem is configured
and started.
This function is automatic.
The QIO subsystem is configured and started. This function is automatic.
The WAN subsystem manager process
($ZZWAN) is configured and started.
This process should start automatically.
The ServerNet LAN Systems Access (SLSA)
subsystem is configured and started.
This subsystem should start automatically.
An Ethernet 4 ServerNet adapter (E4SA) is
installed, configured, and started.
This adapter should start automatically.
A NonStop TCP/IP process and its associated
routes and subnets are defined and started.
To start the NonStop TCP/IP process, use
the STARTCOM and STARTSCF files.
State
The default system configuration with which the system was shipped is complete.
The initial SYSGENR/Install software configuration is complete.
The following subsystems are configured and started:
•
HP Tandem LAN Access Method (TLAM)
•
QIO
An Ethernet controller is installed, configured, and started.
The system name and system number are defined.
The following processes are configured and started:
•
A NonStop TCP/IP process and associated routes and subnets
•
The Expand network control process ($NCP)
The server is running the D40 product version of the Expand subsystem.
A dummy controller is configured and has available unit numbers.