NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Introduction
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
1-40
Installation Overview
Types of ServerNet Cables
NonStop S-series systems support three kinds of ServerNet cables: emitter-coupled
logic (ECL), fiber-optic, and serial-copper.
ECL Cables
ECL cables have two types of connectors. These different types of connectors allow
the cables to connect SEBs to SEBs, MSEBs to MSEBs, or SEBs to MSEBs.
SEB-to-SEB ECL cables are terminated at each end by a large 50-pin connector.
The MSEB-to-MSEB ECL is terminated at each end by a small 50-pin connector.
To connect a SEB to an MSEB, use a SEB-to-MSEB ECL cable.
Figure 1-13. SEB-to-SEB ECL Cable
Figure 1-14. MSEB-to-MSEB ECL Cable
Figure 1-15. SEB-to-MSEB ECL Cable
VST984.vsd
VST104.vsd
MSEB Connector SEB Connector
VST105.vsd