NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Introduction
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
1-53
Installation Overview
MSP IP addresses communicate with the master service processors (MSPs). NonStop
operating system IP addresses communicate with the operating system for the
specified processor. For more information about how these IP addresses are used, see
the NonStop S-Series Planning and Configuration Guide.
To provide security and to make NonStop S-series equipment compatible with your
existing LAN, change these IP addresses before exiting the OSM or TSM Low-Level
Link.
To change the system console, MSP, and operating system access IP addresses, use
the OSM or TSM Low-Level Link. See the documentation appropriate to the software
you are using:
•
OSM Low-Level Link online help
•
OSM User’s Guide
•
TSM Low-Level Link online help
•
TSM Configuration Guide
Subnet 192.231.36.0
Subnet mask 255.255.255.0
Gateway 192.231.36.9
Table 1-6. Preconfigured IP Addresses for a NonStop S-Series Server (continued)
Component IP Address Notes
Primary system console 192.231.36.1
•
All system consoles provided by HP are
preconfigured with IP address
192.231.36.1.
•
Two system consoles on the same LAN
cannot use the same IP address.
•
If the primary system console uses IP
address 192.231.36.1, you must change
the IP address on all other new system
consoles before connecting them to the
LAN.
•
The recommended IP address for a
backup system console is 192.231.36.4.
MSP0 192.231.36.2
•
Access is through the Ethernet port on
the PMF CRU in group 01, module 01,
slot 50.
•
This IP address allows you to establish a
low-level link.