NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Installing Enclosures
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
2-8
Unpack the Enclosures
4. Open the plastic locking clips that hold the shipping package together:
a. Pinch the tabs on the clip together to unlock it.
b. Pull the tabs to remove the clip.
5. Pull the clips completely out of the shipping package and set them aside.
6. Remove the cardboard panels, the padded shipping insert, and the antistatic bag
covering the system enclosure. Set these materials aside.
7. Position the ramp against the pallet.
8. Flip open the twist-lock handles on the pallet end piece.
9. Loosen the end piece by turning the twist-lock handles counterclockwise as far as
they can go:
Figure 2-3. Tabs on Plastic Locking Clip of Shipping Package
Figure 2-4. Loosen End Piece of Pallet by Turning Twist-Lock Handles
VST004.vsd
System Enclosure
(Side View)
Twist-Lock Handles
End Piece
VST951.vsd