NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Installing Enclosures
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
2-9
Unpack the Enclosures
10. Remove the end piece and set it aside.
11. Position the unloading ramp against the on the side from which you removed the
end piece. Position the Velcro strips on either side of the ramp.
Ensure that the Velcro strips hold the ramp firmly against the pallet.
Figure 2-5. Removing End Piece of Pallet
Figure 2-6. Velcro Strips on Loading Pallet
System Enclosure on Pallet
End Piece
VST706.vsd
vst988.vsd
Velcro Strips