NonStop S-Series Hardware Installation and FastPath Guide (G06.29+)

Installing Enclosures
HP NonStop S-Series Hardware Installation and FastPath Guide—541880-002
2-11
Unpack the Enclosures
13. Using at least two people, grasp the enclosure stack frame. Slowly roll the stack off
the pallet and down the ramp:
14. Move the enclosure stack to the location shown in the Floor Plan Diagram.
15. Position the enclosures according to the Enclosure Arrangement Diagram in the
Installation Document Checklist designed for your system.
If you might reduce your system at any point, place enclosures that you might
remove from your system on the top of the stack. The frames can touch one
another. No service space is necessary on the sides of an enclosure.
Figure 2-8. Use Two People to Move an Enclosure Stack
vst986.vsd