NonStop S-Series Operations Guide (G06.24+)

Communications Subsystems: Monitoring and
Recovery
HP NonStop S-Series Operations Guide—522459-007
6-9
Monitoring the NonStop TCP/IP Subsystem
The system displays a listing similar to:
Monitoring CLIPs
To display the current status for a CLIP:
> SCF STATUS SERVER $ZZWAN.#concentrator-name.clip-num
Values for the CLIP number are 1, 2, or 3.
The system displays a listing similar to:
Monitoring the NonStop TCP/IP Subsystem
This subsection describes how to obtain the status for NonStop TCP/IP processes,
routes, and subnets. For additional information, refer to the TCP/IP Configuration and
Management Manual. For NonStop TCP/IPv6, refer to the TCP/IPv6 Configuration
and Management Manual, and the SCF Reference Manual for G-Series RVUs.
Monitoring the NonStop TCP/IP Process
To display the dynamic state of a NonStop TCP/IP process, first list the names of all
NonStop TCP/IP processes:
-> SCF LISTDEV TCPIP
Then type:
> SCF STATUS PROCESS tcp/ip-process-name
where tcp/ip-process-name is the name of the process you want information
about.
-> status PROCESS $ZZWAN.#ZB017
WAN Manager STATUS PROCESS for PROCESS \ICEBAT.$ZZWAN.#ZB017
STATE:...........STARTED
PPIN.............0 ,278 BPIN.............0, 282
-> status server $zzwan.#s01.1
WAN Manager STATUS SERVER for CLIP \COWBOY.$ZZWAN.#S01.1
STATE :..........STARTED
PATH A...........: CONFIUGRED
PATH B...........: CONFIGURED
NUMBER of lines. 2
Line...............0 : $SAT23A
Line...............1 : $SAT23B