NonStop S-Series Operations Guide (G06.24+)

Starting and Stopping the System
HP NonStop S-Series Operations Guide—522459-007
16-12
Troubleshooting and Recovery Operations When
Starting the System
Troubleshooting and Recovery Operations When Starting the
System
Problems that might occur when you start a system are listed next. For recovery
information, refer to the appropriate subsection:
•
Startup Event Stream and Startup TACL Windows Do Not Appear on page 16-12
•
CIIN File Is Not Invoked During System Startup on page 16-14
•
Reload Fails on page 16-14
•
System Load Fails on page 16-15
Startup Event Stream and Startup TACL Windows Do Not
Appear
Although these windows would probably not appear during system startup, you can
use the OutsideView product to configure or open a startup event stream window or
startup TACL window. To open startup event stream windows and startup TACL
windows:
1. Log on to the OSM or TSM Low-Level Link. The Management window appears.
2. Select File>Start Terminal Emulator>For Startup TACL. (See Figure 16-2.)
3. Two OutsideView windows appear, but one launches on top of the other. If you do
not see the TACL prompt in one OutsideView window, check the other OutsideView
window by clicking the buttons on the Windows toolbar. (See Figure 16-3.)
Figure 16-2. Opening a Startup TACL Window
VST813.vsd