NonStop S-Series Operations Guide (G06.24+)

Starting and Stopping the System
HP NonStop S-Series Operations Guide—522459-007
16-13
Troubleshooting and Recovery Operations When
Starting the System
4. Select File>Start Terminal Emulator>For Event Streams.
5. Two OutsideView windows appear, but one launches on top of the other. If you do
not see the TACL prompt in one OutsideView window, you can check the other
OutsideView window (see Figure 16-3).
If any of the four windows do not appear using this method, you can also start them as
follows:
1. Select Start>OutsideView>OutsideView. The OutsideView dialog box appears.
2. Select Session>New. The New Session Properties dialog box appears.
3. On the Session tab, in the Session Caption box, type a session caption name such
as Startup Events or Startup TACL.
4. Click IO Properties. The TCP/IP Properties dialog box appears.
5. Type the IP address of MSP 0 or MSP 1 (depending on which is the primary MSP),
followed by a space, the port number of the window type (303 for the startup event
stream window, and 301 for the startup TACL window).
For example, for the startup event stream window:
192.231.36.2 303
Then, for the startup TACL window:
192.231.36.2 301
6. Click OK. The TCP/IP Properties dialog box closes, and you are returned to the
New Session Properties dialog box.
7. Click OK. The startup event stream window or startup TACL window appears. A
TACL prompt appears in the startup TACL window.
Consult the OSM or TSM Event Viewers for any important system startup messages
logged to the EMS log that you might have missed while opening the terminal-
emulation windows.
Figure 16-3. OutsideView Buttons on the Windows Toolbar
TIF719
Note. If you do not know which MSP is the primary, try MSP 0. If there is no response, try
MSP 1.