NonStop S-Series Operations Guide (G06.24+)

Starting and Stopping the System
HP NonStop S-Series Operations Guide—522459-007
16-21
Procedure to Stop the System Using OSM or TSM
8. Refresh the disks to put them in an orderly state before shutdown. Use the SCF
CONTROL DISK, REFRESH command:
> SCF CONTROL DISK $*,REFRESH
Procedure to Stop the System Using OSM or TSM
To place all processors in a halt state and set the status and registers of the
processors to an initial state:
1. Log on to the OSM or TSM Low-Level Link.
2. On the toolbar, click Processor Status.
3. In the Processor Status dialog box, select all processors to be halted. To select
processors, scroll down the list and select a processor. You can use the Shift key
to select multiple processors, but they must be in numerical order. For example,
you can select processors 2, 3, and 4, but not 2 and 4. To select processors 2 and
4, use the Ctrl key with the left mouse button.
4. Select Processors Actions>Halt.
5. Click Perform action.
6. A message box asks whether you are sure you want to perform a halt on the
selected processors. Click OK.