NonStop S-Series Operations Guide (G06.27+)

Starting and Stopping the System
HP NonStop S-Series Operations Guide522459-008
16-11
Troubleshooting and Recovery Operations When
Starting the System
3. In the Load Processor-n From Disk dialog box:
a. Type the current SYSnn.
b. Select the current configuration file (CONFIG), or if you are unable to load
using the CONFIG file, select a saved version (CONFxxyy).
c. Check the CIIN disabled option if you plan to dump processors.
d. Type the group, module, and slot numbers of the disk from which you want to
load. Although other locations for the system disk are possible, the system
disks are often in these slot locations:
The primary system disk ($SYSTEM-P) is usually located in group 01,
module 01, slot 11.
The mirror system disk ($SYSTEM-M) is usually located in group 01,
module 01, slot 12.
If you are using this procedure because the system disks are in another
location, determine the group, module, and slot numbers for the system disks
before proceeding.
e. Select the ServerNet fabric (X or Y) over which you want the load to take
place.
4. After you have entered the required information into the Load Processor-n From
Disk dialog box, click Load.
5. Monitor the system load in the Processor Status dialog box.
6. Log off of the OSM or TSM Low-Level Link.
Troubleshooting and Recovery Operations When Starting the
System
Problems that might occur when you start a system are listed next. For recovery
information, refer to the appropriate subsection:
Startup Event Stream and Startup TACL Windows Do Not Appear on page 16-12
CIIN File Is Not Invoked During System Startup on page 16-13
Reload Fails on page 16-13
System Load Fails on page 16-14