NonStop S-Series Operations Guide (G06.27+)

Related Reading
HP NonStop S-Series Operations Guide—522459-008
C-4
RESTORE Guardian Disk and
Tape Utilities
Reference Manual
This manual describes these disk and
tape utilities: BACKCOPY, BACKUP,
DCOM, DSAP, RESTORE, and
TAPECOM. This manual supports both
G-series and D-series RVUs; TAPECOM
is not supported for G-series RVUs.
SPOOLCOM Spooler Utilities
Reference Manual
This manual describes the spooler
utilities—Peruse, SPOOLCOM, Font, and
RPSetup— and presents the complete
syntax for these utilities. It also presents a
general introduction to the Spooler
subsystem.
Guardian User’s
Guide
This guide contains information explaining
how to perform routine spooler operations.
It provides background information on
spooler components and tells you how to
use SPOOLCOM to monitor and manage
your system’s spooler operations. It
includes guidelines for identifying and
solving some common problems that can
occur with your spooler subsystem and
the printers associated with it.
Startup and shutdown
command files
NonStop S-Series
Planning and
Configuration Guide
This guide describes how to automate
startup and shutdown procedures.
Subsystem Control
Facility (SCF)
SCF Reference
Manual for G-Series
RVUs
This manual describes the operation of
SCF on G-series RVUs and how it is used
to configure, control, and monitor
subsystems supported by an SCF
interface.
SCF interface to the
Kernel subsystem
SCF Reference
Manual for the Kernel
Subsystem
This manual describes the Kernel
subsystem, and the configuration and
management tasks you can perform using
the SCF interface to the Kernel
subsystem.
SCF interface to the
storage subsystem
SCF Reference
Manual for the
Storage Subsystem
This manual describes how to use SCF to
configure, control, and monitor storage
devices.
SCF interface to the
SLSA subsystem
LAN Configuration
and Management
Manual
This manual describes how to configure,
operate, and manage the ServerNet LAN
Systems Access (SLSA) subsystem. This
manual includes detailed descriptions of
the SCF commands used with the SLSA
subsystem and a quick-reference section
showing SCF command syntax.
Table C-1. Related Reading for Tools and Utilities (page 4 of 6)
Tool Documentation Description