NonStop S-Series Operations Guide (G06.27+)

Determining Your System Configuration
HP NonStop S-Series Operations Guide—522459-008
2-4
Locating System Components in an Enclosure
Locating System Components in an Enclosure
System components within an enclosure are identified by their physical location. To
identify the location of a system component within an enclosure, you need to know:
For example, Figure 2-1 shows how to locate a disk drive by its group, module, and
slot numbers. The group number is shown on a label on the faceplate of the
appearance-side enclosure door. The slot number appears on a label near the slot.
Group number The group number identifies the enclosure in which a system
component is located. The group number of an enclosure is
indicated by the group ID label on the enclosure. (See
Identifying System Enclosures in a NonStop S-Series Server
on page 2-3.)
Module number The module number in a system enclosure is always 01. An
IOAM enclosure contains module 02 and module 03.
Slot number The slot number identifies the position of the system
component within the enclosure. The slot number is indicated
by a label near the slot.
Note. The two-digit number on the group ID labels of an enclosure must match the number
shown by the group ID switches inside the enclosure.