NonStop S-Series Operations Guide (G06.29+)

Communications Subsystems: Monitoring and
Recovery
HP NonStop S-Series Operations Guide—522459-009
6-15
Recovery Operations for Communications
Subsystems
Recovery Operations for Communications
Subsystems
Some general troubleshooting guidelines are:
•
Examine the contents of the event message log for the subsystem. For example,
the WAN subsystem or Kernel subsystem might have been issued an event
message that provides information about the process failure. Event messages
returned by the WAN subsystem and SWAN concentrator are described in the
WANMGR and TRAPMUX sections of the Operator Messages Manual,
respectively.
•
HP provides a comprehensive library of troubleshooting guides for the
communications subsystems. Attempt to analyze the problems and restart the
process or object using the commands described in the appropriate manual listed
in Related Reading on page 6-15. If you are unable to start a required process or
object, contact your service provider.
Related Reading
For more information about monitoring and performing recovery operations for
communications subsystems, see the manuals listed in Table 6-1. The appropriate
manual to use depends on how your system is configured.
For example, if a process is configured using the SCF interface to the WAN subsystem
and then reconfigured with the SCF interface to another subsystem, only the SCF
interface to the other subsystem would provide current information about the
configuration. The SCF interface to the WAN subsystem would provide only
information about the configuration before it changed.
Table 6-1. Related Reading for Communications Lines and Devices (page 1 of 2)
For Information
About... Refer to...
General information
about communications
subsystems
Introduction to Networking for HP NonStop S-Series Servers
Using SCF to monitor
generic processes
SCF Reference Manual for the Kernel Subsystem