NonStop S-Series Operations Guide (G06.29+)

Related Reading
HP NonStop S-Series Operations Guide—522459-009
C-3
OSM package
(continued)
NonStop System
Console Installer
Guide
This guide describes how to install OSM
client-based components and other
required system console software.
PATHCOM TS/MP System
Management Manual
This manual describes the interactive
management interface to the NonStop
TS/MP product. It is intended for system
managers and operators. It provides
guidelines for configuring and controlling a
NonStop TS/MP transaction processing
system and its objects and for monitoring
the status and performance of objects
controlled by PATHMON in a Pathway
environment. It also provides syntax for
all relevant PATHCOM commands, as
well as cause, effect, and recovery
information for all PATHMON, PATHCOM,
and LINKMON error messages.
PEEK PEEK Reference
Manual
This manual describes PEEK, a utility
used to monitor statistical data about
processors.
RESTORE Guardian Disk and
Tape Utilities
Reference Manual
This manual describes these disk and
tape utilities: BACKCOPY, BACKUP,
DCOM, DSAP, RESTORE, and
TAPECOM. This manual supports both
G-series and D-series RVUs; TAPECOM
is not supported for G-series RVUs.
SPOOLCOM Spooler Utilities
Reference Manual
This manual describes the spooler
utilities—Peruse, SPOOLCOM, Font, and
RPSetup— and presents the complete
syntax for these utilities. It also presents a
general introduction to the Spooler
subsystem.
Guardian User’s
Guide
This guide contains information explaining
how to perform routine spooler operations.
It provides background information on
spooler components and tells you how to
use SPOOLCOM to monitor and manage
your system’s spooler operations. It
includes guidelines for identifying and
solving some common problems that can
occur with your spooler subsystem and
the printers associated with it.
Startup and shutdown
command files
NonStop S-Series
Planning and
Configuration Guide
This guide describes how to automate
startup and shutdown procedures.
Table C-1. Related Reading for Tools and Utilities (page 3 of 5)
Tool Documentation Description