NonStop S-Series Planning and Configuration Guide (G06.25+)

Completing the Installation Plan
HP NonStop S-Series Planning and Configuration Guide—523303-015
13-2
Assemble the Installation Document Packet
Assemble the Installation Document Packet
This subsection contains instructions for completing and assembling the installation
forms into a Installation Document Packet. If you are adding to or reconfiguring an
existing system, you might not use all these forms. If you are making a large addition
or reconfiguration, make sure you also have forms that show the system before the
addition or reconfiguration.
Complete and assemble these forms in this recommended order:
1. Installation Document Checklist
2. System Equipment Inventory Form
3. Enclosure Arrangement Diagram
4. Floor Plan
5. Preinstalled I/O Device Cable Checklist
6. For each system enclosure, a System Enclosure Checklist and the following forms
for the components installed in or attached to the enclosure. Place all forms for a
particular system enclosure after the System Enclosure Checklist for that enclosure
and arrange these sets of forms in order by group number.
a. PMF CRU Configuration Form or PMF 2 CRU Configuration Form, IOMF CRU
Configuration Form, or IOMF 2 CRU Configuration Form
b. Network equipment configuration forms
c. ServerNet adapter configuration forms
d. ServerNet Cluster Configuration Form
7. Cabling forms:
a. ServerNet Cabling forms
b. Cross-Row Cabling Worksheets
8. Final Planning Checklist
Include any additional configuration forms, notes or instructions to the installer,
configuration planner, or support planner.
You are authorized to photocopy these installation forms only to install and configure
your system.
An example of an Installation Document Packet is included in Appendix D, Case Study:
ServerNet Cable Lengths.