NonStop S-Series Planning and Configuration Guide (G06.26+)

Initial Configurations
HP NonStop S-Series Planning and Configuration Guide—523303-017
8-7
Initial Default Values for System Attributes
SYSTEM_LIBRARY_
CODE_FILES
TANDEM^LIBRARY^
CODE^FILES
Change in the
CONFTEXT file.
SYSTEM_NAME \NONAME Use SCF for the Kernel
subsystem. See
Changing System Name
and Number on
page 8-8.
SYSTEM _NUMBER 254 Use SCF for the Kernel
subsystem. See
Changing System Name
and Number on
page 8-8.
SYSTEM_PROCESS_
CODE_FILES
TANDEM^PROCESS^
CODE^FILES
Change in the
CONFTEXT file.
SYSTEM_PROCESS_
LIBRARY_FILES
TANDEM^PROCESS^
LIBRARY^FILES
Change in the
CONFTEXT file.
SYSTEM_PROCESS_
MODIFIERS
Buffer space for operator
processes
Automatically set to 128 You cannot change an
automatically configured
system attribute.
Mode for compatibility
distributor
- - Use the EMSCCTRL
commands.
SYSTEM_
PROCESSOR_TYPE
Refer to Processor Types
on
page B-12.
Configured in the
CONFTEXT file.
SYSTEM_
VOLUME_SUBVOL
$SYSTEM.SYS00 Change in the
CONFTEXT file.
TAPE_LABEL_PROCESSING For G05.00 and G06.00
RVUs, the value in the
CONFTEXT file is ignored
after the first time you
change this attribute using
SCF for the storage
subsystem. (After G06.00,
this entry was removed from
CONFTEXT.)
Use SCF for the storage
subsystem.
TIME_LIST_
CONTROL_BLOCKS
Automatically set to 3600
(before G06.08) or 4400
(G06.08 and later)
You cannot change an
automatically configured
system attribute.
TIME_ZONE_OFFSET 0:00 (London) Use SCF for the Kernel
subsystem.
System Attribute Default Value
To Change This
Attribute (page2of2)