NonStop S-Series Planning and Configuration Guide (G06.26+)

Index
HP NonStop S-Series Planning and Configuration Guide—523303-017
Index-9
K
Isolation transformer 12-6
I/O enclosures
See also System enclosures
adding 7-13
balancing 7-13
cabling 5-16
contents 1-3
description 1-3
group numbers 3-11, 3-12
illustrations 1-9, 1-10, 1-13, 1-14
modified 1-3
I/O multifunction 2 (IOMF 2) CRU
See IOMF 2 CRUs
I/O multifunction (IOMF) CRU
See IOMF CRUs
K
Kernel subsystem E-5
Kernel-Managed Swap Facility (KMSF)
See KMSF
KMSF 15-8
/15-9
and operations environment 15-9
default swap file configuration 15-8
EMS messages 15-9
swap files, changing configuration 15-8
L
Labeling cables 12-4
LANs
dedicated 11-1
, 11-5
planning for
dedicated service LAN 11-5
SWAN concentrators 11-2
TSM connections 11-6/11-9
public 11-2
LEDs
group service 4-4
, 4-18
service 4-56
status, on disk drives 4-5
Light-emitting diodes (LEDs)
See LEDs
Linear tape open (LTO) tape drive A-12
LMUs
contents of 4-39
on PMBs 4-39
Local address 1-45
Logical memory units (LMUs)
See LMUs
Loopback test connector 1-26
Low Power Mode 10-6
LTO
See Linear tape open (LTO) tape drive
M
M8800 Gigabit Ethernet 4-port ServerNet
adapter (G4SA)
See Gigabit Ethernet 4-port ServerNet
adapter (G4SA)
M8840 Fibre Channel ServerNet adapter
(FCSA)
See Fibre Channel ServerNet adapter
(FCSA)
Maintenance switch 4-71
Maintenance, remote, configuring 15-9
Manual sets E-2/E-10
Master service processor
See also Service processors (SPs)
functions 4-47
location 4-47
Memory
adding to processors 9-8
components of 4-39
maintenance during power loss 10-6,
10-8
PMB slots 4-39
sizes 8-3, B-12
tape drives for 16-GB PMF CRUs 1-15
virtual 15-8
Memory banks
See LMUs