NonStop S-Series Planning and Configuration Guide (G06.27+)

ServerNet Cabling

HP NonStop S-Series Planning and Configuration Guide—523303-019

5-12

ServerNet Cabling: Tetra 16 Topology

This subsection describes the ServerNet cable connections for the Tetra 16 topology,

which is supported by the following models of NonStop S-series servers:

•

NonStop S7000, S7400, S7600, and S7800 servers support a maximum of:

Eight processor enclosures

Sixteen I/O enclosures (two for each processor enclosure)

•

NonStop Sxx000 servers support a maximum of:

Eight processor enclosures

Thirty-six I/O enclosures (five for each processor enclosure on the inner

tetrahedron and four for each processor enclosure on the outer tetrahedron)

Note. IOAM enclosures can replace I/O enclosures in cabling diagrams. For information about

what is supported, contact your HP representative.

Note. Cabling information for IOAM enclosures is available to your HP trained service provider

in the Modular I/O Installation and Configuration Guide.

Note. IOAM enclosures are supported in group 01. For important configuration

restrictions, refer to IOAM Enclosures

on page 4-69.

Tetra 16 Cabling Diagram, X Fabric on page 5-13

Tetra 16 Cabling Diagram, Y Fabric on page 5-14

Tetra 16 Cabling Table, Processor Enclosures on page 5-15

Tetra 16 Cabling Table, I/O Enclosures on page 5-16

Cabling Diagram, IOAM Enclosure, X Fabric, G06.25 and G0.26 on page 5-19