NonStop S-Series Planning and Configuration Guide (G06.28+)

Index
HP NonStop S-Series Planning and Configuration Guide—523303-020
Index-12
P
Power failures, system behavior
during 10-6/10-7
Power interface board (PIB) 1-34, 4-15
Power interlock 4-37, 4-56
Power loss, memory maintenance
during 10-6
Power monitor and control unit (PMCU)
See PMCU
Power outlets
convenience receptacles 12-7
labeling 12-7
power plugs
Integrity NonStop NS-series
server G-1, G-2
Power requirements
branch circuits 12-8
earth grounding 12-6
isolation transformer 12-6
local regulations 12-6
Power shelf
front panel 1-30, 4-59
power components 4-15
service class 1-34
type of enclosure with 1-6, 4-14
Power supplies 4-71
Power supply
disk-drive enclosure 1-33
in a power shelf
service class 1-30
slot locations 4-15
Powering on the system 7-1, 7-10
Power-fail delay time 10-6
configuring 10-7
Low Power Mode 10-6
maximum
calculated 10-6, 10-7
configured 10-6
configuring 10-7
default 10-7
Power-fail delay time (continued)
minimum 10-6
operational considerations 10-7
short power failures 10-6
Power-fail ride-through time
See Power-fail delay time
Power-on cables 7-1, 7-10
PPP 1-50
Preinstalled I/O Device Cable Checklist
completing, procedure 13-11
purpose of 13-11
Primary system console
See System consoles
Problem reporting and tracking, creating
policies for 9-5
Processor and memory board (PMB)
See PMB
Processor enclosures
See also System enclosures
contents 1-3
group numbers 3-12
illustrations 1-7, 1-8, 1-11, 1-12
Processor multifunction 2 (PMF 2) CRUs
See PMF 2 CRUs
Processor multifunction (PMF) CRUs
See PMF CRUs
Processor type
NSR-C processor B-12
NSR-D processor B-12
NSR-E processor B-12
NSR-G processor B-12
NSR-H processor B-12
NSR-T processor B-12
NSR-V processor B-12
NSR-W processor B-12
NSR-X processor B-12
NSR-Y processor B-12
NSR-Z processor B-12