NonStop S-Series Planning and Configuration Guide (G06.28+)

Index
HP NonStop S-Series Planning and Configuration Guide—523303-020
Index-15
S
ServerNet SAN
fabrics in 1-48
fault tolerance of 2-1, 2-10
parallel operation 2-1
representations of 2-3
ServerNet switch board 4-70
ServerNet topology
See Tetra 16 topology
See Tetra 8 topology
ServerNet wide area network (SWAN)
concentrator
See SWAN concentrator
ServerNet wide area network (SWAN)
concentrators
See SWAN concentrators
ServerNet/DA
listed F-3
service class 1-32
ServerNet/FX 2 adapter
listed F-3
See also ServerNet adapters 1-34
service class 1-34
ServerNet/FX adapter
See also ServerNet adapters
service class 1-34
subsystem E-4
Service classes of CRUs 1-30
Service LED 4-56
Service processors (SPs)
communication within a group 4-48
description of 4-46
domains 4-47
fault tolerance of 4-47
location of 4-46
master service processors
(MSPs) 4-47
operations on systems that are
down 4-47
peer service processors 4-47
PMCUs 4-8
Service processors (SPs) (continued)
power failures 10-7
Service side
See also specific components
group ID label 4-3
group service LED 4-18
IOMF CRUs 4-50
module ID label 4-18
PMF CRU 4-32
SEBs 4-18
ServerNet adapters 4-25
slots in 4-16
Setup configuration
cable connections 11-7
security 11-7
to system console 8-18
Shutdown files
automating 15-11
sequence of 15-11
Side panel, enclosure 4-62
Signal reference grid 7-2, 7-12, 12-7
Simple Network Management Protocol
(SNMP) 1-49, 4-67
Single-mode fiber-optic (SMF) PIC 4-21
Site planning
additional resources 12-1
summary 12-1
Site selection, considerations for 12-2
Slots
51 and 52 4-30
memory 4-39
ServerNet 4-29
SLSA subsystem manager E-4
SMB 4-46
SMF PIC
cable distances 4-21
in an IOMF 2 CRU 4-55
in an MSEB 4-21
service class 1-32
used in F-4