NonStop S-Series Planning and Configuration Guide (G06.29+)

Initial Configurations
HP NonStop S-Series Planning and Configuration Guide—523303-021
8-7
Initial Default Values for System Attributes
Initial Default Values for System Attributes
System Attribute Default Value
To Change This
Attribute (page1of2)
BREAKPOINT_CONTROL_
BLOCKS
Automatically set to 50 You cannot change an
automatically configured
system attribute.
BUILD_Z0_PROCESS Automatically built during
system generation
You cannot change an
automatically configured
system attribute.
DAYLIGHT_SAVINGS_TIME NONE Use SCF for the Kernel
subsystem.
DP2_UPSOPTION OFF For G05.00 and later
G-series RVUs, use
SCF for the storage
subsystem.
FILES_TO_COPY_TO_
NEW_SYSTEM
TANDEM^FILES^TO^ COPY Change in the
CONFTEXT file.
FORMATTER_TEMPLATE TANDEM^FORMATTER^
TEMPLATE
Change in the
CONFTEXT file.
FORMATTER_TEMPLATE_
FILES
TANDEM^FORMATTER^
TEMPLATE^FILES
Change in the
CONFTEXT file.
INITIAL_COMMAND_FILE or
INITIAL_COMINT_INFILE
$DSMSCM.SYS.CIIN Configured in the
CONFTEXT file.
MAXIMUM_SYSTEMS Automatically set to 255 You cannot change an
automatically configured
system attribute.
OPERATOR_PROCESSORS Automatically set to
processors 0 and 1
You cannot change an
automatically configured
system attribute.
POWERFAIL_
DELAY_TIME
30 seconds Use SCF for the Kernel
subsystem.
PROCESS_
CONTROL_BLOCKS
Automatically set to 1800
(before G06.08), 2200
(G06.08 to G06.G06.18) or
4000 (G06.19 and later)
You cannot change an
automatically configured
system attribute.
PROCESSORS Automatically configured You cannot change
automatically configured
system attributes.
STANDARD_MICROCODE TANDEM^STANDARD^
MICROCODE
Change in the
CONFTEXT file.
SUPER_SUPER_
IS_UNDENIABLE
- - Change in the
CONFTEXT file.