NonStop S-Series Planning and Configuration Guide (G06.29+)

Initial Configurations
HP NonStop S-Series Planning and Configuration Guide—523303-021
8-12
Command Files for Objects Not Configured in the
Initial CONFIG File
Command Files for Objects Not Configured in the Initial CONFIG
File
The following command files that configure and start objects that are not configured in
the initial CONFIG file. These files can serve as examples for you to modify as
necessary. They also provide the basic files for recovery from system failure.
Files Used to Create the Initial CONFIG File
Note. Objects that are not configured in the CONFIG file must be reconfigured after a system
load.
File Name Purpose
$SYSTEM.ZSYSCONF.STARTCOM Starts TCP/IP services using the LAN
devices configured by the SCF0000 file:
1. Starts the TCP/IP processes
2. Invokes the STARTSCF file
3. Starts the TELSERV and LISTNER
processes
$SYSTEM.ZSYSCONF.STARTSCF Contains SCF commands to configure and
start the TCP/IP routers and subnets and to
start the processes used by the SWAN
concentrator.
File Name Purpose
$SYSTEM.SYSnn.CONFBASE Configures:
•
$SYSTEM disk volume
•
$ZZKRN Kernel subsystem manager
•
$ZZSTO storage subsystem manager
•
$ZHOME reliable home-terminal
process
$SYSTEM.ZSYSCONF.SCF0000 Configures and starts:
•
Disk drives
•
Tape drives
•
ServerNet adapters
•
Data communications subsystems
•
SNMP configuration parameters for
TSM
•
Several other system processes