NonStop S-Series Planning and Configuration Guide (G06.29+)

Initial Configurations
HP NonStop S-Series Planning and Configuration Guide—523303-021
8-14
Naming Conventions Used in the SCF0000 File for
SCF Objects
Naming Conventions Used in the SCF0000 File for SCF Objects
This table describes the SCF0000 file-naming conventions for many SCF objects. This
information is also contained in the $SYSTEM.ZSYSCONF.SCF0000 file.
Refer to Objects That Must Not Be Renamed on page 8-11 before renaming any SCF
objects.
<cabid>
is a two-digit number that identifies the group number of the enclosure.
<slot>
is the actual physical slot number in the enclosure.
Type of
Object Naming Convention Example Description
Disk drive $D<cabid><slot> $D3217 I/O group 32, slot 17
Tape drive $T<cabid><slot> $T0150 Processor group 01, slot 50
LAN adapter E<cabid><slot> E8254 I/O group 82, slot 54
LIFs L<cabid><portid> L51A I/O group 51, slot 53,
ServerNet connector 2
TCP process $ZB<cabid><portid> $ZB51A TCP/IP process for the
associated LIF
Telnet
process
$ZN<cabid><portid> $ZN51A Telnet process associated
with TCP/IP
Listener
process
$ZP<cabid><portid> $ZP51A Listener process associated
with TCP/IP
TFTP
process
$ZF<cabid><portid> $ZF51A TFTP process associated with
TCP/IP
Fast Ethernet
adapter
F<cabid><slot> F5154 I/O group 51, slot 54
Token ring
adapter
TR<cabid><slot> TR5155 I/O group 51, slot 55
WANBoot
process
$ZW<cabid><portid> $ZW51A WANBoot associated with
TCP/IP
SWAN
concentrator
S<adapter> S19 Nineteenth SWAN
concentrator
SS7 Telco $C<cabid><portid> $C Telco process associated with
SS7 protocol
G4SA E<group><module><slot#> G1121 A G4SA in group 11, module
2, slot 1
G4SA LIF L<group><module><slot>
<port>
L1125C LIF for PIF at location
11.2.5.0.C