NonStop S-Series Planning and Configuration Guide (G06.29+)

Initial Configurations
HP NonStop S-Series Planning and Configuration Guide—523303-021
8-15
SCF Commands to Automate Disk Configuration
<portid>
is the slot number and port number mapped in the following way:
<adapter>
is a number in the range 00 through 99.
SCF Commands to Automate Disk Configuration
You can use SCF to configure your system so that, upon system load or the insertion
of a disk CRU, several tasks are automated. These are tasks and commands to
automate disk processes.
For more information on these tasks and the procedures to automate them, see the
SCF Reference Manual for the Storage Subsystem.
Slot
Number
Router
Port
Number <portid>
Slot
Number
Router
Port
Number <portid>
51 0 0 53 0 8
51 1 1 53 1 9
51 2 2 53 2 A
51 3 3 53 3 B
52 0 4 54 0 C
52 1 5 54 1 D
52 2 6 54 2 E
52 3 7 54 3 F
Process SCF Command Purpose
Auto-
configuration
ALTER SUBSYS $ZZSTO,
AUTOCONFIG { OFF | ON }
To automatically configure internal
disks
Auto-start ALTER SUBSYS $ZZSTO,
AUTOSTART { OFF | ON }
To automatically start the disk
process when an internal disk CRU
is inserted in a slot
Auto-revive ALTER SUBSYS $ZZSTO,
AUTOREVIVE { OFF | ON }
To automatically start a disk revive,
if necessary, during a system load
or when a disk CRU is inserted in a
slot
Note. The SCF AUTOCONFIG command cannot be used if the storage devices in your
enclosures are interleaved.