NonStop S-Series Planning and Configuration Guide (G06.29+)

The Planning and Configuration Process
HP NonStop S-Series Planning and Configuration Guide—523303-021
9-8
Changing an Existing System
Changing an Existing System
Changing the System Name or System Number
The system name and Expand system (node) number can be changed through the
SCF Kernel subsystem. Because the attributes that change the system name and
system number are stored in a SEEPROM in the enclosure backplane, changes to
them require a system reset and reload to take effect. You must also update references
to the system name and system number in the DSM/SCM SQL database, SNMP, and
TMF. The procedure for changing the system name and system number is described in
detail in the NonStop S-Series Hardware Installation and FastPath Guide.
When you change the system name of a system already installed at your site, update
the system name on all the forms in the Installation Document Packet.
If you change the system number of a system already installed, update the system
number on the System Enclosure Arrangement Form in the Installation Document
Packet.
Adding a System Enclosure
Add-on enclosures are shipped with the ServerNet adapters and disk drives already
installed. The procedure for physically installing an enclosure is described in the
NonStop S-Series Service Provider Supplement. The procedure for adding a system
enclosure to a running system is described in the NonStop S-Series System Expansion
and Reduction Guide.
Adding Memory to a Processor
To add memory to a processor that has fixed memory configurations, you replace the
PMF CRU with another having more memory. Where fixed memory configurations are
not available, you add memory by adding or replacing memory units in the PMF CRU.
Adding a System Console
For information about adding a system console, see the NonStop S-Series Hardware
Installation and FastPath Guide. For information about configuring an added system
console, see the OSM Migration Guide, TSM Configuration Guide, or NonStop S-
Series Hardware Installation and FastPath Guide.
Note. The Expand system (node) number can be changed through the SCF Kernel
subsystem, the system serial number cannot.
Caution. IOAM enclosures must be installed by service providers trained by HP.