NonStop S-Series Planning and Configuration Guide (G06.29+)

The Planning and Configuration Process
HP NonStop S-Series Planning and Configuration Guide—523303-021
9-18
Adding or Changing the Configuration of Other
Peripheral Devices
Adding or Changing the Configuration of Other Peripheral
Devices
The procedure for adding or changing the configuration of a peripheral device depends
on the device being added or changed. Configuration changes to peripheral devices
can be performed online.
In G06.12 and previous RVUs, the system manager must explicitly configure the
WANBoot, TFTP, and SNMPTMUX processes. In G06.13 and later RVUs, the WAN
manager process can configure these processes automatically.
For information about configuring peripheral devices, refer to the manual that describes
the device.
After you have added a peripheral device:
•
Test the new system configuration.
•
Modify your startup and shutdown files to include the added peripheral device.
Startup and shutdown files are described in Startup and Shutdown Files on
page 15-10.