NonStop S-Series Planning and Configuration Guide (G06.29+)

Completing the Installation Plan

HP NonStop S-Series Planning and Configuration Guide—523303-021

13-2

Assemble the Installation Document Packet

This subsection contains instructions for completing and assembling the installation

forms into a Installation Document Packet. If you are adding to or reconfiguring an

existing system, you might not use all these forms. If you are making a large addition

or reconfiguration, make sure you also have forms that show the system before the

addition or reconfiguration.

Complete and assemble these forms in this recommended order:

1. Installation Document Checklist

2. System Equipment Inventory Form

3. Enclosure Arrangement Diagram

4. Floor Plan

5. Preinstalled I/O Device Cable Checklist

6. For each system enclosure, a System Enclosure Checklist and the following forms

for the components installed in or attached to the enclosure. Place all forms for a

particular system enclosure after the System Enclosure Checklist for that enclosure

and arrange these sets of forms in order by group number.

a. PMF CRU Configuration Form or PMF 2 CRU Configuration Form, IOMF CRU

Configuration Form, or IOMF 2 CRU Configuration Form

b. Network equipment configuration forms

c. ServerNet adapter configuration forms

d. ServerNet Cluster Configuration Form

7. Cabling forms:

a. ServerNet Cabling forms

b. Cross-Row Cabling Worksheets

8. Final Planning Checklist

Include any additional configuration forms, notes or instructions to the installer,

configuration planner, or support planner.

You are authorized to photocopy these installation forms only to install and configure

your system.

An example of an Installation Document Packet is included in Appendix D, Case Study:

ServerNet Cable Lengths.