NonStop S-Series Planning and Configuration Guide (G06.29+)

Completing the Installation Plan

HP NonStop S-Series Planning and Configuration Guide—523303-021

13-11

Preinstalled I/O Device Cable Checklist

If you have already installed I/O device cables for use with this system, use the

Preinstalled I/O Device Cable Checklist to tell the installer which cables are to be

connected to the system equipment being installed.

(This information also included in the Floor Plan.)

Complete a Preinstalled I/O Device Cable Checklist as follows.

The column headed by a check mark is provided for you to check off each line item to

make certain that all required preinstalled I/O device cables are installed and ready for

operation.

Task Comments

Enter the name of the system in the

System Name column.

This system name must match the system name

on all other forms in this packet.

Enter the information from the cable

ID tag in the Cable ID Tag column.

The cable ID tag is the physical label attached to

the I/O device cable.

In the Floor Plan field, describe the

location of the cable.

If the room contains only one preinstalled cable,

listing the room number is sufficient. Otherwise,

provide a more detailed description.

Enter the page number of this page

and the total number of pages of this

form in the Page ___ of ___ field.

Some forms are designed to be duplicated.

When you have completed this form,

enter the date in the Date field.