NonStop S-Series Planning and Configuration Guide (G06.29+)

Completing the Installation Plan
HP NonStop S-Series Planning and Configuration Guide—523303-021
13-23
ServerNet Cabling Forms
ServerNet Cabling Forms
The ServerNet cabling forms are provided to help you determine the number and type
of ServerNet cables that you need to cable a system in one row. If you are cabling a
system with enclosures arranged in multiple rows, you also use the Cross-Row Cabling
Worksheets described on page 13-25.
The following cabling forms are located in alphabetic order in Appendix C, Blank
Forms:
Complete a ServerNet Cabling form as follows.
ServerNet Cabling: Tetra 8 Topology, I/O Enclosures
ServerNet Cabling: Tetra 8 Topology, Processor Enclosures
ServerNet Cabling: Tetra 16 Topology, I/O Enclosures 11-25
ServerNet Cabling: Tetra 16 Topology, I/O Enclosures 31-45
ServerNet Cabling: Tetra 16 Topology, I/O Enclosures 51-64
ServerNet Cabling: Tetra 16 Topology, I/O Enclosures 71-84
ServerNet Cabling: Tetra 16 Topology, Processor Enclosures
Task Comments
Make photocopies of the ServerNet
cabling forms you need.
On each ServerNet cabling form, enter
the system name and page _ of _.
This system name must match the system name
on all other forms in this packet.
On each ServerNet cabling form, mark
the row for each cable required for your
system.
For example, place a check mark next to
“01 51 02 51.”
For each ServerNet cable required for
your system, enter the estimated
length you need in the Length Needed
column.
Enter the part number of each cable in
the Part Number column.
When you have completed this form,
enter the date in the Date field.