NonStop S-Series Planning and Configuration Guide (G06.29+)

Index
HP NonStop S-Series Planning and Configuration Guide—523303-021
Index-3
D
Convenience receptacles, requirements
for 12-7
Cooling fan
See Fan
CRUs
identifying 1-23
IOMF
See IOMF CRU
PMF
See PMF CRU
removal 6-1
replacement tools 1-30
storage 4-4
terminators 4-7
Customer-replaceable units (CRUs)
See CRUs
D
Data communications, planning for 12-3
Database, configuration 15-4, 15-5
DC power cable
processor enclosures 4-37
Dedicated LANs 11-1, 11-5
See also LANs
Dedicated service LAN 11-5
Delay, power-fail
See Power-fail delay time
Delivery route, preparing 12-13
Dial-ins, countries not supported in 11-13,
12-5
Dial-outs, countries not supported in 11-13,
12-5
Disaster prevention and recovery, creating
policies for 9-5
Disk drive enclosure 1-21
components 1-21, 4-75
connections 1-22, 4-77
FRU identification 1-28
Disk drives
36-GB for NonStop Sx6000 servers 4-7
adding 9-12
automated tasks for 8-15
changing the configuration of 9-12
disk management 4-5
factory-default configurations 8-5
for 16 GB processors 8-4
internal 4-5
minimum configuration 8-5
mirrored volume configuration 4-5
SCSI bus assignments for 4-5
slot assignments, $SYSTEM 4-5
slots for 4-4, 4-5
status LEDs 4-5
Disk drives, internal B-14
Document packet 9-5, 9-8, 13-1, 13-2
Domain name servers 1-48
Domain names 1-47
Door
See Enclosure door
Dotted decimal format of IP
addresses 1-46
E
ECL cables 5-2
See also ServerNet cables
ECL PIC 4-21
in an IOMF 2 CRU 4-54
Electrostatic discharge (ESD)
See ESD
Emergency power-off (EPO)
See EPO
Emitter-coupled logic (ECL)
See ECL cables
See ECL PIC
Enclosure Arrangement Diagram
completing, procedure 13-7
example 13-7
purpose of 13-7