NonStop S-Series Planning and Configuration Guide (G06.29+)

Index
HP NonStop S-Series Planning and Configuration Guide—523303-021
Index-9
P
Peer service processors 4-46
See also Service processors (SPs)
Peripheral devices
See also specific devices
adding 9-18
changing the configuration of 9-18
power requirements 12-9
service requirements 12-2
Persistence manager process ($ZPM) 15-4
PFC 12-8
Phone lines 12-5
PIB 4-15
PIC
emitter-coupled logic (ECL) 4-21, 4-25
multimode fiber-optic (MMF) 4-21
node-numbering agent (NNA) 4-21
serial-copper (SCu) 4-21
single-mode fiber-optic (SMF) 4-21
Ultra SCSI 4-50
Planned outages
defined 10-1
installing software product revisions
(SPRs) 15-2
minimizing duration of 10-4
minimizing frequency of 10-2/10-4
when required 15-1
Planning tasks
adding disk drives 9-12
adding memory 9-8
adding ServerNet adapters 9-14
adding SWAN concentrators 9-15
adding system enclosures 9-8
final steps 13-28
Plug-in card (PIC)
See PIC
PMB
LMUs 4-38
memory slots 4-38
physical description 4-37
PMCU
appearance side 4-8
fan connections 4-12
functions 4-8
service processors 4-8
slots 4-8
PMF 2 CRU
See also PMF CRU
faceplate 4-35
ports 4-36
ServerNet Router 2 4-48
PMF CRU
16 GB processor configuration
requirements 4-25
AC power 4-36, 4-55
communication pathways 6-2
configuration form, completing 13-16
faceplate 4-32, 4-33, 4-34
functions 4-48
LEDs 4-32
ports 4-36
power interlock 4-36
power supply configuration 12-9, B-11
ServerNet router 1 4-47
topics 4-31/4-47
Point-to-Point Protocol (PPP) 1-45
Port Access Method (PAM) subsystem E-4
Post-installation tasks, new system,
overview of 9-7
Power distribution unit 4-70
Power factor correction (PFC) 12-8
Power failures, system behavior
during 10-6/10-7
Power interface board (PIB) 4-15
Power interlock 4-36, 4-55
Power loss, memory maintenance
during 10-6
Power monitor and control unit (PMCU)
See PMCU