NonStop S-Series Planning and Configuration Guide (G06.29+)

Terms and Concepts
HP NonStop S-Series Planning and Configuration Guide—523303-021
1-33
TSM Guided Procedures
The guided procedures automate many of the repetitive subtasks and verifications
involved in CRU replacement. They also assist you in performing manual subtasks
required to replace a CRU online while maintaining the system availability.
These tools:
•
Check that the system is in good working order before beginning the replacement
•
Stop components affected by the replacement
•
Start components after the replacement
•
Can be used for replacing or upgrading CRUs
Replacing an IOMF CRU, PMF CRU, Power Supply, or
ServerNet Device Adapter
Replacing an IOMF CRU, PMF CRU, Power Supply, or ServerNet Device
Adapter
1-33
Add Switch 1-34
Configure ServerNet Node 1-34
Guided Replacement Toolkit (GRT) 1-34
Replace IOMF 1-34
Replace PMF 1-35
Replace Power Supply 1-35
Replace SEB or MSEB 1-35
Replace SNDA 1-35
Replace Switch Component 1-35
SWAN Fast Firmware Update 1-36
Troubleshoot ServerNet Fabric 1-36
Note. Before you use a guided procedure, print the appropriate sections of the online help
included with all guided procedures. To access online help, select Help > Procedure Help.
In a System Running Use
TSM product version T7945AAW (shipped with
G06.12) or earlier
Guided Replacement Toolkit (GRT)
TSM product version T7945AAX (shipped with
G06.13) or later
The guided replacement procedure for
the specific CRU
G06.12 or earlier if you install SPR T7945AAX The guided replacement procedure for
the specific CRU