NonStop S-Series Service-Side Door Add-On Package Read Me

Himalaya S-Series Service-Side Door Add-On Package Read Me–141618

Himalaya S-Series Service-Side

Door Add-On Package Read Me

This card summarizes the procedure to install a cosmetic cover (door) on the service side

of a Himalaya S7000 or S70000 system enclosure. Perform the following steps (you

need a Phillips screwdriver):

1. Obtain a service-side door add-on package (part number 142139), and verify that it

contains the following items:

•

Adapter frame (140849)

•

Service-side door (121301); preinstalled on adapter frame

•

4 M5 Phillips screws, plus extras (107469)

•

4 M5 KEPS nuts, plus extras (108444)

•

4-mm diagonal wrench, for unlocking door

2. Remove the door from the adapter frame, then install that frame on the enclosure:

a. Align the mounting hooks of the frame with the top, enlarged holes on the cable

channels of the enclosure.

b. Push the frame in and down so that the mounting hooks engage; verify that the

frame is supported by and flush against the cable channels.

c. Verify that the four frame and cable channel mounting holes are aligned.

d. Using the four M5 Phillips screws and four M5 KEPS nuts, perform the

following steps for each of the four mounting holes:

1. Insert a Phillips screwdriver through the access hole in the frame, then use

the screwdriver to insert a Phillips screw completely into the mounting hole.

See Figure 1

(OVER)

Figure 1. Inserting a Phillips Screw Into a Mounting Hole

PAGE 1
Himalaya S-Series Service-Side Door Add-On Package Read Me This card summarizes the procedure to install a cosmetic cover (door) on the service side of a Himalaya S7000 or S70000 system enclosure. Perform the following steps (you need a Phillips screwdriver): 1.
PAGE 2
Himalaya S-Series Service-Side Door Add-On Package Read Me Document History 2. From the inside of the cable channel, use your fingers to install a KEPS nut on the protruding end of that screw. 3. Insert a Phillips screwdriver through the access hole in the frame, then use the screwdriver to tighten the Phillips screw while you hold the KEPS nut in place with your free hand. See Figure 2. Figure 2. Tightening a Phillips Screw in a Mounting Hole 3.