NonStop S-Series System Expansion and Reduction Guide

HP NonStop S-Series System Expansion and Reduction Guide—522465-009
D-1
D
Stopping Devices and Processes
This appendix gives examples of identifying devices and processes before you move
or stop them.
As stated in Step 5. Prepare and Stop Devices and Processes
on page 4-8, you need
to identify all devices and processes before you can stop or move them. This important
step in system reduction must be done successfully if the donor system is to continue
to function well after the enclosures have been physically removed.
This appendix contains some examples of how to carry out this step. Use these
examples as a guide, along with the manuals for the remaining subsystems, to plan the
specific commands needed for your system reduction. The procedures for identifying,
preparing, and stopping these devices are subsystem-specific.
Based on Worksheet 8, the possible devices are listed in Table D-1
along with their
corresponding manuals and a reference to an example if any.
Table D-1. References and Examples (page 1 of 2)
Device Subsystem Manual
Example
on Page
Internal disk drive Storage SCF Reference Manual for the
Storage Subsystem
D-2
External tape drive Storage SCF Reference Manual for the
Storage Subsystem (if attached
through PMF CRU or IOMF CRU)
--
6760 ServerNet/DA Manual (if
attached through ServerNet device
adapter)
Adapters (in general) -- -- D-5
E4SA, GESA, and G4SA Expand-
over-IP
Expand Configuration and
Management Manual
LAN Configuration and
Management Manual
D-6
IPX/SPX IPX/SPX Configuration and
Management Manual
--
PAM PAM Configuration and
Management Manual
--
SNAX SNAX/XF and SNAX/APN
Configuration and Management
Manual
--