Open System Services Installation Guide (G06.24+, H06.03+, J06.03+)

Open System Services Installation Guide—429954-004
5-1
5 STOPOSS Utility
The STOPOSS utility stops the OSS filesets (but not the OSS processes).
Usage Considerations:
•
HP recommends that you log on with a user ID in the SUPER group ID to run
STOPOSS.
•
STOPOSS is on the installation subvolume ZOSSINS. You must run STOPOSS
from ZOSSINS.
•
STOPOSS no longer expects the SPI definition files to be installed on $SYSTEM if
the EASYSETUP^EMSVOL param is used (see SPI Definition Files on page 1-6).
Running STOPOSS
Run STOPOSS either by entering this command at a TACL prompt or by putting this
command in the operating system’s shutdown file:
If these processes are not running, STOPOSS starts them from TACL:
$ZSMP and $NULL are only started if the EASYSETUP^STARTUP param is set with
$NULL, $ZSMP or both.
Status and Error Messages
The status messages that STOPOSS displays are described in Appendix B, OSS
EasySetup Status Messages.
The error messages that STOPOSS displays are described in Appendix C, OSS
EasySetup Error Messages.
Example 5-1 on page 5-2 shows a STOPOSS session, including the status messages.
User input is shown in bold.
[RUN] STOPOSS
Process Name
$ZSMP Security manager
$NULL NULL
$ZPMON OSS Monitor