Open System Services Management and Operations Guide (G06.25+, H06.03+)

Open System Services Monitor
Open System Services Management and Operations Guide—527191-002
12-15
ADD SERVER Command
°
Specifies that the inode cache for the fileset USER3 should be flushed to disk
after approximately 10 seconds to make its recovery faster by decreasing the
time when the cache is considered dirty.
°
Performs automatic recovery of the fileset USER3 using a copy of the FSCK
program in processor 5 after a shutdown or failure. The recovered fileset is left
in a started state.
°
Sends FSCK output after an automatic recovery to the spooler $S.#USER3.
•
To add the fileset USER1 to the storage-pool configuration file USRPOOL using
the volume catalog on $DATA, the mount point /user1, and allowing a maximum
of 600000 inodes, enter the following command:
ADD /OUT CMDLOG/ FILESET $ZPMON.USER1, CATALOG $DATA, POOL
USRPOOL, MNTPOINT "/user1", MAXINODES 600000
ADD SERVER Command
The ADD SERVER command adds an OSS server to the configuration administered
through the OSS Monitor.
The syntax of the ADD SERVER command is:
OUT filename
specifies the name of a Guardian output file for informational messages. You can
either read this file with a text editor or display it with the FUP COPY command.
SERVER server_processname
specifies the server being added. server_processname has the following form:
[ $ZPMON.]servername
ADD [ /OUT filename/ ] SERVER server_processname
[ , TYPE NAME ]
, CPU primary_processor
[ , AUTORESTART ntimes ]
[ , BACKUPCPU backup_processor ]
[ , BACKUPCPUOK { TRUE | FALSE } ]
[ , INODECACHE size1 ]
[ , LINKCACHE size2 ]
[ , MAXWAITTIME seconds2 ]
[ , SQLTIMEOUT seconds ]