Open System Services Management and Operations Guide (G06.25+, H06.03+)

Open System Services Monitor
Open System Services Management and Operations Guide—527191-002
12-33
ALTER SUBSYS, ALTER MON, and ALTER
PROCESS Commands
You can specify the following options in any order. You must specify at least one
option:
AUTOSTART { AUTO | MANUAL }
specifies whether the automatic startup service is enabled.
AUTO
All filesets and servers that are configured to use the automatic startup service
are automatically restarted after a system load or restart.
MANUAL
Filesets and servers are not automatically restarted after a system load or
restart. This is the default value.
When you use AUTOSTART MANUAL, automatic recovery and remounting of
filesets that were not in a stopped state when a failure or shutdown occurred are
still recovered or restarted when an OSS name server or the OSS Monitor is
restarted; this activity is described in Automatic Restart of Filesets During OSS
Monitor Startup on page 5-8 and Automatic Restart of Filesets After OSS Name
Server Failure on page 5-9.
FSCKCPU processor_number
specifies the processor number of the processor in which FSCK runs when the
SCF DELETE FILESET or DIAGNOSE FILESET command is executed and no
processor was configured for FSCK use with that fileset or the configured
processor for the fileset is unavailable. Valid values are either in the range 0
through 15 or equal to -1.
The value -1 specifies that FSCK should run in the processor used by the copy of
DP2 for the fileset catalogs.
The initial value (set when the configuration database is created) is -1.
If the FSCKCPU option is omitted, the configured value is unchanged.
IOTIMEOUT seconds
specifies the number of seconds that the OSS Monitor waits for a response from
an OSS name server to an OSS Monitor request.
Valid values are in the range 1 through 300. The initial value (set when the
configuration database is created) is 60.
If the IOTIMEOUT option is omitted, the configured timeout interval is unchanged.
REPORT [ filename2 | NULL ]
specifies the target for the FSCK log file and for CVT and FUP output from SCF
commands when no report file was configured for use with that fileset or the