Open System Services Management and Operations Guide (G06.25+, H06.03+)

Messages
Open System Services Management and Operations Guide—527191-002
A-21
FSCK Inconsistency and Error Messages
If the REPAIR ALL option was specified in the command, this is an informational
message only; no corrective action is needed.
216
filename
indicates the affected file.
Cause. The inode corresponding to the indicated file does not refer to that file.
Effect. A currently unused inode is allocated, the ZYQ file is renamed to correspond to
the new inode, and the inode is placed in the OSS /lost+found directory.
Recovery. If the REPAIR ALL option was not specified in the Subsystem Control
Facility (SCF) DIAGNOSE FILESET command, the catalog is still in an inconsistent
state. Reissue the command with the REPAIR ALL option.
If the REPAIR ALL option was specified in the command, this is an informational
message only; no corrective action is needed.
217
Cause. While attempting to resolve a ZYQ conflict previously reported in FSCK
message 216, FSCK was unable to find an available inode.
Effect. No further attempt is made to resolve these conflicts.
Recovery. Informational message only; no corrective action is needed.
218
Cause. The FSCK utility was run with the FILESET ROOT option, but the fileset
catalog does not correspond to a root fileset.
Effect. FSCK converts the fileset to a root fileset.
Recovery. If the REPAIR option was not specified or the REPAIR NONE option was
specified in the Subsystem Control Facility (SCF) DIAGNOSE FILESET command, the
catalog is still in an inconsistent state. Reissue the command with the REPAIR
SERIOUS or REPAIR OPEN option.
MINOR 216 - ZYQ File Conflict - filename
WARNING 217 - Fileset is Full and there are still ZYQ File
Conflicts
SERIOUS 218 - Not a Root Fileset