Open System Services Management and Operations Guide (G06.25+, H06.03+)

OSS Management Utilities
Open System Services Management and Operations Guide—527191-002
C-12
OSSSETUP Utility
OSSSETUP is intended to provide a quick way to initially configure an OSS
environment. You can later build on the configuration OSSSETUP creates by manually
configuring additional resources or altering your initial configuration.
You must not use the OSSSETUP utility when an OSS configuration already exists on
your node. For example, you cannot use OSSSETUP when:
•
Your system was preconfigured by HP, but OSSREMOV has not been run.
•
OSSSETUP has previously been run, but OSSREMOV has not been run.
•
You have manually configured your OSS environment.
Command
To run OSSSETUP, enter these commands:
DEFAULTS
causes the utility to execute without interactive dialog. The resulting configuration
is described in Configuration Files on page 4-6.
? | HELP
suppresses creation of an OSS environment configuration and provides general
help text for the utility.
When no parameter is specified on the command line, the OSSSETUP utility runs
interactively. However, you cannot enter HELP or ? at subsequent OSSSETUP
prompts to see descriptive information about the corresponding dialog screens.
Summary Displays
As OSSSETUP executes, it displays summaries of your responses and asks for
confirmation that the corresponding configuration is acceptable before proceeding.
Figure C-1, Figure C-2, and Figure C-3 on page C-13 contain samples of these
progress displays.
VOLUME $SYSTEM.ZOSSINS
[ RUN ] OSSSETUP [ DEFAULTS | ? | HELP ]