Open System Services Management and Operations Guide (G06.25+, H06.03+)

Operating the OSS Environment
Open System Services Management and Operations Guide—527191-002
2-20
Monitoring OSS Processes
12. Remove all previously saved catalogs by entering the following TACL command:
RUN $tsvvol.ZOSS.CVT PURGE SERIAL mmmm IN $old_vol.ZX0nnnnn
$tsvvol
specifies the disk volume of the installation target subvolume (TSV) containing
the CVT utility. See Managing and Repairing Fileset Catalog Files on
page 5-38 for more information on the CVT utility.
mmmm
specifies the FSCK serial number of a previous FSCK diagnose or repair
operation. See Generated Catalog Files on page 5-31 for more information on
FSCK serial numbers.
$old_vol
specifies the disk volume on which you previously saved catalog volume files;
such files have names of the form:
PXffmmmm
ff
specifies one of the following:
mmmm
is the FSCK serial number.
nnnnn
specifies the device identifier for an OSS fileset.
When this procedure is completed, no one can use an OSS file until you reconfigure all
filesets and restore or reinstall OSS files. See the Open System Services Installation
Guide for information on installing the complete OSS product set.
Monitoring OSS Processes
You can monitor OSS process execution using:
•
OSS shell commands with special HP extensions
•
Guardian TACL commands
IN An old inode file for the catalog
LI An old link file for the catalog
LO An old FSCK log file for the catalog