Open System Services Management and Operations Guide (G06.29+, H06.07+)

Managing Servers
Open System Services Management and Operations Guide—527191-005
4-19
Configuration Database Files Used for the OSS
Message-Queue Server
where disk1, disk2, and disk3 are volume names specified to OSSSETUP.
Figure 4-2 on page 4-12 shows how a storage-pool file (ZOSSPOOL in the figure)
corresponds to the information in other database files in an OSS environment
configuration.
Configuration Database Files Used for the OSS Message-Queue
Server
To start the OSS message-queue server, the OSS Monitor requires a ZOSSSERV file
in the subvolume $SYSTEM.ZXOSSMON.
The ZOSSSERV file is the OSS message-queue server configuration database, and
it contains an automatically created entry that identifies the characteristics of the OSS
message-queue server process. This file must be edited by the system manager using
the SCF ALTER SERVER command.
When a default ZOSSSERV file is created by the OSS Monitor, it contains a #ZMSGQ
entry for the OSS message-queue server process, $ZMSGQ.
Beginning with RVU G06.10, when HP shipped a system with the OSS environment
preconfigured, the #ZMSGQ entry matched the default, as follows:
Beginning with RVU G06.15, when HP shipped a system with the OSS environment
preconfigured or you used the OSSSETUP utility to configure your system and
Storage-pool file content:
•
Preconfigured or all defaults
accepted
•
Single pool volume specified
•
Two pool volumes specified
•
Three or more pool volumes
specified
$OSS
disk1
disk1
, disk2
all specified disks
$OSS
disk1
disk1
, disk2
all specified disks
$OSS
disk1
disk2
disk3
Attribute
Default Values When
ZOSSSERV Is Created by the
OSS Monitor
Initial Values When ZOSSSERV Is
Delivered on a Preconfigured
System
BACKUPCPU 0 0
CPU 1 1
MSGMQB 65535 65535
MAXMQID 32 32
MAXMSG 32 * MAXMQID = 1024 32 * MAXMQID = 1024
MSGMSIZE 32000 32000
SERVER #ZMSGQ #ZMSGQ
TYPE MSGQ MSGQ