Open System Services Management and Operations Guide (G06.29+, H06.07+)

Open System Services Monitor
Open System Services Management and Operations Guide—527191-005
12-44
DIAGNOSE FILESET Command
The syntax of the DIAGNOSE FILESET command is:
OUT filename1
specifies the name of a Guardian output file for informational messages. You can
either read this file with a text editor or display it with the FUP COPY command.
FILESET [$ZPMON.]filesetname
is the name of the fileset you are diagnosing. Only names currently defined in the
ZOSSFSET file are valid values.
The $ZPMON prefix can be omitted if you have previously specified $ZPMON in an
SCF ASSUME command.
You can specify the following options in any order:
CPU processor_number
specifies the processor number of the processor where the FSCK utility will run.
Valid values are in the range 0 through 15.
You can also specify the default processor with the FSCKCPU parameter of the
SCF ALTER SUBSYS command.
If you do not specify a processor by either means, the default processor is the
processor on which the copy of DP2 used for the fileset catalog is running.
DETAIL
produces a detailed report and places it in the FSCK log file.
If the DETAIL option is omitted, only a summary report is produced.
DIAGNOSE [ /OUT filename1 / ] FILESET [$ZPMON.]filesetname
[ , CPU processor_number ]
, DETAIL ]
[ , OPTION { START | STOP } ]
[ , REPORT filename2 ]
[ , { STATUS }
{ REPAIR { ALL | NONE | OPEN | SERIOUS } }
{ UPGRADE }
{ DOWNGRADE } ]