Open System Services Management and Operations Guide (G06.29+, H06.07+)

Messages
Open System Services Management and Operations Guide—527191-005
A-41
Numbered Messages
Cause. A Subsystem Control Facility (SCF) START FILESET command was issued
for a fileset whose mount point does not represent a valid OSS pathname. (The
pathname does not exist or is not a directory.)
Effect. The fileset is not started.
Recovery. Perform the following steps:
1. Use the SCF INFO FILESET command to check the spelling of the mount point
pathname.
2. Use the OSS shell ls command to verify that an OSS directory exists to serve the
mount point.
3. Use the SCF ALTER FILESET command to change the configuration of the fileset
so that it uses a valid OSS directory as the mount point, then reissue the START
FILESET command.
For information about the INFO FILESET, ALTER FILESET, and START FILESET
commands, see Section 5, Managing Filesets.
16
volname
is the name of the affected disk volume.
Cause. A Subsystem Control Facility (SCF) START FILESET command failed
because the catalog volume is inaccessible.
Effect. The fileset is not started.
Recovery. Perform one or more of the following actions:
•
Make sure that the catalog disk volume is not down. If the volume is down, bring it
up.
•
Examine the configuration file with the SCF INFO FILESET command. Use the
SCF ALTER FILESET command to correct the disk volume name if necessary.
•
Reissue the START FILESET command.
For information about the INFO FILESET, ALTER FILESET, and START FILESET
commands, see Section 5, Managing Filesets.
OSS E00016 Unable to access catalog volume volname