Open System Services Management and Operations Guide (G06.29+, H06.07+)

Messages
Open System Services Management and Operations Guide—527191-005
A-57
Numbered Messages
60
maxinodesvalue
indicates the MAXINODES value being used. This value is also stored in the
configuration database for the fileset.
Cause. The specified MAXINODES value is less than 110 percent of the number of in-
use inodes. This message can occur when an OSS name server tries to mount an
existing fileset and the previous maximum value did not allow reasonable growth.
Effect. This is an informational message only.
Recovery. No immediate action is required. The disk capacity of the fileset should be
checked to determine if its MAXINODES value should be increased further.
61
Cause. A Subsystem Control Facility (SCF) START FILESET command was entered,
but one or more of the disk volumes configured for the storage creation pool for the
fileset cannot be used to store newly created OSS files. The storage pool for the fileset
has reached the limit of 256 disk volumes and the storage creation pool file now
contains one or more new disk volume names.
Effect. This is an informational message only.
Recovery. No immediate action is required. However, the disk capacity of the fileset
should be checked in case new OSS files will need to be created.
Use the SCF STATUS FILESET command with the DETAIL option to check the disk
volumes in the storage creation pool. If the storage creation pool contains no disk
volumes eligible for new file creation, possible actions include:
•
Delete unused files from the fileset to free space on disk volumes already in the
storage pool (when all OSS files have been removed from a disk volume, it is no
longer part of the storage pool unless it is also in the storage creation pool). Then
use an SCF CONTROL FILESET command with the SYNC option to update the
storage creation pool from the pool edit file.
•
Move files from this fileset to another fileset with more growth capacity to free
space on disk volumes already in the storage pool (when all OSS files have been
removed from a disk volume, it is no longer part of the storage pool unless it is also
in the storage creation pool). Then use an SCF CONTROL FILESET command
with the SYNC option to update the storage creation pool from the pool edit file.
OSS W00060 The fileset is started, but MAXINODES value is
changed to maxinodesvalue
OSS W00061 The fileset is started, but not all the volumes in
the pool edit file are eligible for file creation