Open System Services Management and Operations Guide (G06.30+, H06.08+, J06.03+)

SEL [ NOT ] state
directs the command to apply only to filesets that are in the specified state or, when the NOT
field is used, only to filesets that are not in the specified state. Valid values for state are:
DescriptionValue
The fileset is being diagnosed by the FSCK utility.DIAGNOSING
The fileset is started (mounted).STARTED
The fileset is ready to be started (mounted) or diagnosed.STOPPED
The fileset is in an unknown state.UNKNOWN
The information returned for a summary report has the following format:
OSS Status FILESET fileset-devicename
FilesetName State LastError ErrorDetail
filesetname state error error-detail
fileset-devicename
is the name of the fileset whose status is displayed, shown as a device of the OSS Monitor
process.
filesetname
is the name of the fileset whose status is displayed.
state
describes the state of the fileset.
DescriptionValue
The fileset is being diagnosed by the FSCK utility.DIAGNOSING
The fileset is started (mounted).STARTED
The fileset is ready to be started (mounted) or diagnosed.STOPPED
The fileset is in an unknown state.UNKNOWN
error
is the error number of the last OSS Monitor error that occurred during an operation on the
fileset. See “Numbered Messages” (page 361) for an explanation of a specific error number.
error-detail
is the error number of the Guardian file-system error (if any) reported with the error value.
For information about Guardian file-system errors, see the Guardian Procedure Errors and
Messages Manual.
The information returned for a detailed report has this format:
OSS Detailed Status FILESET fileset-devicename
State.................................. state
MountTime.............................. mount-time
LastError.............................. error
ErrorDetail............................ error-detail
ErrorTime.............................. error-time
FsckName............................... volume
LastControlSyncTime.................... time3
AlterAfterSyncOrMount.................. status1
*AuditEnabled........................... status2
*Buffered............................... type
*ReadOnly............................... status3
OSS Monitor SCF Command Reference Information 315