Open System Services Management and Operations Guide (G06.30+, H06.08+, J06.03+)

AlterAfterSyncOrMount status1
indicates whether the configuration of the fileset has changed after its most recent start or
synchronization with ZOSSFSET:
DescriptionValue
The fileset configuration has not changed.FALSE
The fileset configuration has changed.TRUE
This field is displayed only if the fileset is in the STARTED state.
LastError error
is the error number of the last OSS Monitor error that occurred during an operation on the
fileset. See “Numbered Messages” (page 361) for an explanation of a specific error number.
ErrorDetail error-detail
is the error number of the Guardian file-system error (if any) reported with the error value.
For information about Guardian file-system errors, see the Guardian Procedure Errors and
Messages Manual.
LastControlSyncTime time3
is the timestamp for the time when the configuration of the fileset was last synchronized with
ZOSSFSET, in the form dd mmm yyyy hh:mm:ss.mil. If a CONTROL FILESET command
with the SYNC option has not been issued since the fileset was last started, this field is blank.
This field is displayed only if the fileset is in the STARTED state.
FsckName volume
is the name of the Guardian disk volume used by the FSCK utility to store its log file.
AuditEnabled status2
indicates whether changes to the content of the fileset are being audited:
DescriptionValue
The fileset is not audited.OFF
The fileset is audited.ON
This field is displayed only if the fileset is in the STARTED state.
Buffered type
indicates the type of buffering performed for the fileset:
DescriptionValue
When a request or transaction requires a write to the PXINODE or PXLINK file, the corresponding
write is buffered to the PXLOG file. Also uses the fast file-creation feature for writing new file labels.
CREATE
When a request or transaction requires a write to the PXINODE or PXLINK file, the corresponding
write is buffered to the PXLOG file. Does not use fast file creation.
LOG
Does not buffer anything. Any request or transaction that requires a write to the PXINODE or PXLINK
file also requires a write to the PXLOG file. Does not use fast file creation.
NONE
This field is displayed only if the fileset is in the STARTED state.
OSS Monitor SCF Command Reference Information 317