Open System Services Management and Operations Guide (G06.30+, H06.08+, J06.03+)

• Details from the message or messages generated
• Supporting documentation such as Event Management Service (EMS) logs, trace files, and
a processor dump, if applicable
If your local operating procedures require contacting the Global Customer Support Center
(GCSC), supply your system number and the numbers and versions of all related products as
well.
100
SERIOUS 100 - Corrupt PXLINK Record - Parent:parent, Child:child,
Name:linkname
parent
indicates the inode number of the parent end of the link.
child
indicates the inode number of the child end of the link.
linkname
identifies the affected link.
Cause
The FSCK utility detected a corrupt record in the PXLINK file.
Effect
This record is not included in the new PXLINK file. Any inode orphaned as a result is placed in
the OSS /lost+found directory with the name #inode-number.
Recovery
If the REPAIR option was not specified or the REPAIR NONE option was specified in the Subsystem
Control Facility (SCF) DIAGNOSE FILESET command, the catalog is still in an inconsistent state.
Reissue the command with the REPAIR SERIOUS or REPAIR OPEN option.
If the REPAIR SERIOUS, REPAIR OPEN, or REPAIR ALL option was specified in the command,
this is an informational message only; no corrective action is needed.
101
SERIOUS 101 - Duplicate Link ID - Parent:parent, Child:child, Name:link
linkname
parent
indicates the inode number of the parent end of the link.
child
indicates the inode number of the child end of the link.
linkname
identifies the affected link.
Cause
The indicated link has the same link ID as another link between the same two inodes.
Effect
When FSCK creates a new PXLINK file, it assigns a new unique link ID.
Recovery
If the REPAIR option was not specified or the REPAIR NONE option was specified in the Subsystem
Control Facility (SCF) DIAGNOSE FILESET command, the catalog is still in an inconsistent state.
Reissue the command with the REPAIR SERIOUS or REPAIR OPEN option.
If the REPAIR SERIOUS, REPAIR OPEN, or REPAIR ALL option was specified in the command,
this is an informational message only; no corrective action is needed.
344 Messages