Open System Services Management and Operations Guide (G06.30+, H06.08+, J06.03+)

Recovery
Perform one or more of the following actions:
• Use the SCF INFO SERVER command to check for invalid information in the configuration
of the failing server.
• If this system is running AF_UNIX Release 2 software, modify startup scripts to remove
entries that start the OSS local server process, $ZPLS.
• Verify that the processors used by the server are running.
• Check the server program file security permissions.
• Look up the PROCESS_CREATE_ error information in the Guardian Procedure Errors and
Messages Manual. Correct the problem and start the server.
5
OSS E00005 Invalid value for parameter paramname
paramname
identifies the command parameter with the invalid value.
Cause
A Subsystem Control Facility (SCF) ADD or ALTER command contained a parameter value that
was invalid.
Effect
The command is not processed.
Recovery
Reissue the command with a valid value.
6
OSS E00006 No attributes have been specified for this command.
Cause
A Subsystem Control Facility (SCF) command contained a parameter without a required value
or was missing a required parameter.
Effect
The command is not processed.
Recovery
Reissue the command with an appropriate parameter or value.
8
OSS E00008 Exceeded maximum I/O error retry limit on name
name
identifies the affected entity.
Cause
During the execution of a Subsystem Control Facility (SCF) command, an OSS server had a
recurring I/O error and the retry limit was reached. This error usually occurs when either a
processor fails, an OSS name server process is not running, or a disk device is malfunctioning.
Effect
The OSS Monitor stops processing the command.
OSS Monitor Messages 363