Open System Services Management and Operations Guide (G06.30+, H06.08+, J06.03+)

3. Restart the OSS Monitor.
18
OSS E00018 Configuration contains invalid data
Cause
A fileset cannot be started because the configuration record for it has become corrupted.
Effect
The command is not processed.
Recovery
A serious problem exists. Perform the following actions:
1. If possible, check and correct the configuration of the fileset using the Subsystem Control
Facility (SCF) INFO FILESET and ALTER FILESET commands. Reassigning an existing attribute
to the fileset might fix the configuration record problem.
2. Restart the fileset.
If the problem persists, check the Event Management Service (EMS) log for related messages.
Contact your service provider and provide all relevant information as follows:
• Description of the problem and accompanying symptoms
• Details from the message or messages generated
• Supporting documentation such as EMS logs, trace files, and a processor dump, if applicable
If your local operating procedures require contacting the Global Customer Support Center
(GCSC), supply your system number and the numbers and versions of all related products as
well.
The fileset probably cannot be used again. If you have a recent backup, use the SCF DELETE
FILESET command to delete the fileset entry from the configuration file, then recreate the
configuration record with the SCF ADD FILESET command and restore the fileset files from the
backup copy.
19
OSS E00019 There is no disk volume in pool filename
filename
is the Guardian filename of the affected storage-pool file.
Cause
A Subsystem Control Facility (SCF) START FILESET command was issued but the fileset has no
disk volumes. The indicated storage-pool file contains no entries.
Effect
The command is not processed.
Recovery
Make sure that the storage-pool file contains at least one disk volume name. Reissue the command.
22
OSS E00022 Invalid value for attribute attribute-name
attribute-name
is the name of the affected attribute.
Cause
A Subsystem Control Facility (SCF) ADD or ALTER command failed because a specified attribute
has a value that is invalid.
Effect
The command is not processed.
OSS Monitor Messages 367